Parallel connectors for use in hazardous areas

It is becoming more and more common to install ring equipotential bonding conductors in the hazardous areas of industrial plants

^{For linking and connecting wires in hazardous areas of industrial plants I picture: evonik}

Especially for linking electrical equipment and connecting the ring equipotential bonding.

The parallel connector CU/gal Sn has been tested to be non-sparking up to the designated residual current.

On installation it is fitted with a spring washer under the nut to prevent self-loosening.^* It has been tested as suitable for use in potentially explosive atmospheres

• ex-zones 1 / 2 (gases and explosion group IIC) and
• ex-zones 21 / 22 (dust)

This parallel connector does not possess any potential source of ignition (mechanical device) and as such does not fall under the European Ex-directive 2014/34/EU. It is therefore suitable for unlimited application in potentially explosive atmospheres.

Available in two versions:

Parallel connector Cu/gal Sn, 16 - 95 mm2

Parallel connector Cu/gal Sn, 16 - 150 mm2

^*in accordance with DIN EN 62305-3 (VDE 0185-305-305-3, suppl. 2)